Filament spool holder for Ikea SKADIS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament spool holder for Ikea SKADIS.
- Ocena
- 5 / 5
- Polubienia
- 87
- Pobrania
- 420
- Wydruki
- 2
- Wyświetlenia
- 2640
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
I HAVE NEW AND MUCH BATTER VARIANT OF THE HOLDER. PLEASE FOLLOW THE LINK.
I have tried few different spool holder solutions for Skadis but I wasn't happy, I needed something simple and decided to make my own. I have 76 cm and 36 cm boards mounted next to each other so I needed at least three holders to hold the weight.
I made two holder models, one is just mirrored version of another, it is needed if holders are mounted on opposite sides of the Skadis boards.
I used 22 mm wooden rods, I oiled them with linseed oil, but it is not necessary. I also made end stops for the rods. Those are not necessary since rod is held pretty tight, it just looks nicer. I used 3 mm wood screws to hold them connected to the rod.
I printed holders in PETG and PLA, both works just fine.
Supports are needed for L shaped hooks.