1 / 5
Bearing - Radial & Thrust 51 OD x 15 ID x 18 Thk — zdjęcie 1
1 / 5

Bearing - Radial & Thrust 51 OD x 15 ID x 18 Thk

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Roller Bearing with a single print. The rollers are semi-triangular for higher thrust load.

Ocena
5 / 5
Polubienia
4
Pobrania
50
Wydruki
1
Wyświetlenia
276
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Rather than use ball bearings, I tried using a semi-triangular cross section to improve the longitudinal (thrust) load capacity.  

When printed, the actual dimensions were: 50.87 OD, 17.65 thick; 14.57 ID mm.

I plan to use this in a competition to design a rubber band-driven car for school.  

There was some stick-slip after it came off the printer.  To reduce this, I put a bolt and nut through the center and turned the bolt and inner race with a drill while holding the outer race. 

There remains a little stick-slip in one spot when rotated.  But it turns quite easily. 

I used a clearance (tolerance) between mating parts at 0.2 mm.  That might need to be adjusted for other printers.   And it might be too small.

Does anyone know why this culture uses “tolerance” when the engineering term is “clearance” between mating parts?  An engineering tolerance is an allowance from the design in the manufactured part, i.e. 1.5 mm +/- .04 mm.  

Tagi