1 / 5
Bearing - Radial & Thrust 51 OD x 15 ID x 18 Thk — image 1
1 / 5

Bearing - Radial & Thrust 51 OD x 15 ID x 18 Thk

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Roller Bearing with a single print. The rollers are semi-triangular for higher thrust load.

Rating
5 / 5
Likes
4
Downloads
50
Makes
1
Views
276
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution

Rather than use ball bearings, I tried using a semi-triangular cross section to improve the longitudinal (thrust) load capacity.  

When printed, the actual dimensions were: 50.87 OD, 17.65 thick; 14.57 ID mm.

I plan to use this in a competition to design a rubber band-driven car for school.  

There was some stick-slip after it came off the printer.  To reduce this, I put a bolt and nut through the center and turned the bolt and inner race with a drill while holding the outer race. 

There remains a little stick-slip in one spot when rotated.  But it turns quite easily. 

I used a clearance (tolerance) between mating parts at 0.2 mm.  That might need to be adjusted for other printers.   And it might be too small.

Does anyone know why this culture uses “tolerance” when the engineering term is “clearance” between mating parts?  An engineering tolerance is an allowance from the design in the manufactured part, i.e. 1.5 mm +/- .04 mm.  

Tags