Meraki MR44 / MR46 Ceiling Mount Bracket Adapter Thingy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I can't believe nobody has made this yet. In an effort to go 2.5Gbe, I bought an MR46 used on eBay for about $270 (Dec…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 71
- Wydruki
- 1
- Wyświetlenia
- 483
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I can't believe nobody has made this yet. In an effort to go 2.5Gbe, I bought an MR46 used on eBay for about $270 (Dec 2023). Price was low due to not having a ceiling bracket.
Problem solved.
EDIT: Don't print in PLA. Fell off my ceiling within 24 hours. xD Re-printed in PETG, made a slight modification in V2 so the clip is always under pressure. Problem solved. Again.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
20%
Filament: COEX PLA White
Notes:
I'd probably recommend PETG instead of PLA, since the warmth of this device will likely weaken the grab over time potentially. (I'm rolling the dice on PLA; My ceiling isn't that tall, and its carpet below so.... eh)
The nubs need supports to be perfect. You might get away without it. It should audibly snap into place. :)Category: Electronics