HotBox Holder for Ikea Lack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for the Wham Bam HotBox on an Ikea Lack table. The height clears an Ender 3 S1.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The HotBox is slightly wider than the Ikea Lack table, so this mount extends to support the HotBox. I have an Ender 3 S1, so the height was made to just barely clear it. This does leave a gap around the bottom; not ideal for chamber temps, but probably better for the electronics at the base of the printer. Plus, it's been totally fine for printing ABS.
The mount was attached with double sided tape. It was the thick foam kind, which added a bit of extra clearance on the top.
This prints with no supports if oriented at 45 degrees on the print bed. (See photo)