Dishwasher clean/dirty indicator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
No clean/dirty indicators were what I wanted, so modeled my own. Magnetized, large letters and low-friction slider.
- Ocena
- 4,609 / 5
- Polubienia
- 877
- Pobrania
- 2438
- Wydruki
- 23
- Wyświetlenia
- 13 292
- Oceny
- 23
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
I wasn't satisfied with any of the models I found for clean/dirty dishwasher indicators, so I decided to practice some modeling and make my own. My wife hates the feel and sound of 3d print material sliding together, so I used a low-friction slider to reveal the correct state.
Slider snaps over the top of body after printing. Magnet holes fit for 15 x 3mm, I glued the magnets in slightly proud for best adhesion.
This is the first published version, follows alpha v1 that had .01 tighter tolerances, only 2 magnets, and deeper/smaller letter holes.p