Dyson Supersonic Wide Tooth Comb wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A magnetic wall mount for the new Dyson Supersonic Wide Tooth Comb.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 89
- Wydruki
- 0
- Wyświetlenia
- 649
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was inspired by the original model by Steve5092, but recreated from the ground up. OP had the best one I have seen online, but was missing the wall mount for the new “wide tooth comb” adapter (yes, that's the official name from Dyson :D). I have also made the magnet holes smaller for my 8mm wide round magnets. I put a stack of 2 magnets in each hole, but it's up to your preference on how strong you want the magnetic connection to be.
The model is printed easily with no supports, I printed mine with PLA and 0.2mm layer height. I have thought about creating one with embedded magnets with a pause in printing, but this is a much simpler solution and you can choose the ammount of magnets you put in the holes. My recommendation - put the magnets in the holes, attach the Dyson adapter and rotate it a bit so that the magnets settle in their natural position. After that put a few drops of superglue in the hole and spray it with super glue accelerator so that it solidifies instantly. Then you can fix it to you wall using a double-sided tape.