Dyson Supersonic Wide Tooth Comb wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A magnetic wall mount for the new Dyson Supersonic Wide Tooth Comb.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 89
- Makes
- 0
- Views
- 648
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was inspired by the original model by Steve5092, but recreated from the ground up. OP had the best one I have seen online, but was missing the wall mount for the new “wide tooth comb” adapter (yes, that's the official name from Dyson :D). I have also made the magnet holes smaller for my 8mm wide round magnets. I put a stack of 2 magnets in each hole, but it's up to your preference on how strong you want the magnetic connection to be.
The model is printed easily with no supports, I printed mine with PLA and 0.2mm layer height. I have thought about creating one with embedded magnets with a pause in printing, but this is a much simpler solution and you can choose the ammount of magnets you put in the holes. My recommendation - put the magnets in the holes, attach the Dyson adapter and rotate it a bit so that the magnets settle in their natural position. After that put a few drops of superglue in the hole and spray it with super glue accelerator so that it solidifies instantly. Then you can fix it to you wall using a double-sided tape.