1 / 2
Nozzle to clean e.g. the drain pipe of a shower
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To clean the drain pipe of a shower, I have designed this nozzle with one inlet and 3 outlets.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Part is printed with PETG and is designed for an interface M8. I am using a polyurethan tube ⌀10 x ⌀6,5 where I add a thread M8 for the nozzle. I recommend to cut the thread step by step to avoid screw tap get stucked.
Print instruction:
- supports: organic support recommended to ensure good adheasion to print bed
- layer height: 0,2mm or 0,3mm
- nozzle diameter: 0,4mm or 0,6mm
- brim: NO
- enclosure: NO
Note:
The picture show a vase with a diameter of about 150mm to show water jet of the nozzle.