Stash Tray and 1" Sq. Extrusion Stand + Levoit Air Purifier Holder Topper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed more surface space + elevate my room air filter. I had a 8" extrusion laying around and this is the result.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 835
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution
Nothing too fancy here. I'll say it gets the intended job done.
This is for the Levoit Air Purifier 6.5"D x 6.5"W x 10.4"H
https://www.amazon.com/dp/B09GTRVJQM?ref=ppx_yo2ov_dt_b_product_details&th=1
There are a few file variations depending on what you want. I personally like the deep 4 pocket tray the best. It is the strongest however it does take the longest to print.
The tray has holes and channels running in the base from the middle to the corners to allow a chord to pass through the corner along the bottom and up the middle concealing the cable. There are holes in the face of the base to allow hinges and maybe lids for the compartments later.
The Levoit Holder has a spot for your spare M3sN and your M3x10 to use as a set screw to keep it from sliding down the extrusion.
Hope you guys like it.