DJI Avata Motion Controller Stand (v1 or v2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mod for the DJI Motion Controller so you can set the remote down without sending your drone into a flat spin.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 153
- Wydruki
- 2
- Wyświetlenia
- 739
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
The DJI Motion Controller is awesome, but if you need to set it down for any reason, it sends your drone into a flat spin. Slip it on your controller and voila - you can set it down and it remains vertical.
It's a nice tight fit, based on a scan of the controller and designed to stay on all the time without glue or anything. There is a hole in the back so you can charge without removing the stand.
I printed it in ASA, but tough PLA works well too. I used .2 layer height, 4 perimeters @ .6 width, 15% infill and 1.2mm top and bottom minimum thickness. The rear hole prints better with a little support, and I painted the seams to follow the controller seams (you'll see them in the model).