DJI Avata Motion Controller Stand (v1 or v2)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mod for the DJI Motion Controller so you can set the remote down without sending your drone into a flat spin.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 153
- Makes
- 2
- Views
- 739
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
The DJI Motion Controller is awesome, but if you need to set it down for any reason, it sends your drone into a flat spin. Slip it on your controller and voila - you can set it down and it remains vertical.
It's a nice tight fit, based on a scan of the controller and designed to stay on all the time without glue or anything. There is a hole in the back so you can charge without removing the stand.
I printed it in ASA, but tough PLA works well too. I used .2 layer height, 4 perimeters @ .6 width, 15% infill and 1.2mm top and bottom minimum thickness. The rear hole prints better with a little support, and I painted the seams to follow the controller seams (you'll see them in the model).