Blink Mini Camera Holder for Prusa Mini+ / MK3 / MK4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Attaches to the front of your Prusa to hold a Blink Mini camera.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 392
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
There is a different arm for each machine (one for Mini+ and one for MK4/MK3). Print that and attach it using the existing screws on the faceplate of the printer. (Remove existing screws, add arm, then screw back in.)
Then the attachment (circular piece) snaps on to the top of the arm. You can add a little glue if you're concerned it won't say but it is a pretty tight fit so I don't think it's necessary.
There is an indentation where the camera sits to put an optional 3x8mm magnet to hold the camera in place (see photo). I found the vibrations of Input Shaper can make the camera jiggle around and turn sometimes so I added this feature. Magnets I used are here: https://a.co/d/66fUDNe
There is an indentation in the back of the arm in case you have a side basket on your Mini like me (see photo).
I couldn't decide if I liked the “Mini" branding straight or at an angle so I included both versions. Use a filament swap to get the color pop shown in photos.
Please post your makes and give feedback!