1 / 2

Galvanized Trash Can

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Handy Handcrafts

@HandyHandcrafts

It's a trash can, for your trash - Print the Can in Vase mode

Ocena: 4,833 / 5
Polubienia: 169
Pobrania: 2047
Wydruki: 14
Wyświetlenia: 5167
Oceny: 12

Aktualizacja u źródła: 4 lut 2026

Informacje o modelu

Źródło: Printables
Kategoria: Office
Licencja: Creative Commons — Attribution — Noncommercial

Szczegóły Pliki (4)Wydruki i komentarze (Wydruki: 14) (Komentarze: 26)Remiksy (1)Kolekcje (186)

There are a few trash cans out there. I though i'd make my own.

Printing

Print the Trash Can right side up in "Vase Mode" with a Extrusion Width of .8mm with a .4mm nozzle diameter

For the Lid print right side up with strips drawn with the “Paint-On supports” tool (Organic). Make sure the supports are perpendicular to the 1st layer lines on the large flat bottom layer on the lid see image to right. This minimizes the support material and also makes the supports easier to remove.

Filament - PLA or PETG is fine

Infill - 15%

Layer Height -

Trash Can - .30mm in Vase Mode

Lid - .10mm Detail Mode (The smaller layer thickness reduces the visibility of the layer lines and shows more detail)

Supports - See my comments above about supports for the Lid

Parimeters - 3 for Lid

Additional Parts - None

Bed Adhesion - You may want some glue stick to ensure good bed adhesion.

Rafts - None

Scaling - Maybe, but I have not tried it, but if you do scale us your print , let me know how it goes.

Filament Change - None