1 / 7
Trotec laser retrofit with 40W CO2 tube — zdjęcie 1
1 / 7

Trotec laser retrofit with 40W CO2 tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I have an old Trotec laser engraver. It was built in 1998 and worked quite well until this summer 2023. So I would say…

Ocena
0 / 5
Polubienia
2
Pobrania
13
Wydruki
0
Wyświetlenia
468
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

I have an old Trotec laser engraver. It was built in 1998 and worked quite well until this summer 2023. So I would say that it was a very reliable machine but it now suffers from its old age:

  • laser tube is dead
  • software is very very old fashioned and runs (tries to run) under windows 95 operating system

So it was time to trash this machine... But it looked so professionnal that I decided to refurbish it with more modern electronics.

  • As I am an hobbyist I couldn't afford to buy a new RF laser tube, so I decided to change it to a cheap 40W CO2 tube
  • As I love ESP32 and micro controllers I decided as well to design my own controller boards based on GRBL FluidNC software.

Follow this project to see how all this can work as expected !

Result here : https://youtu.be/0KS32yQQGEo

Full project is open sourceOpen hardware and accessible on my Hackaday's project page : https://hackaday.io/project/193893-retrofitting-an-old-laser-engraver

Category: Electronics

Tagi