NEMA17_Cover_GX16
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use: I used this Cover from @tijao at my MPCNC Nema17 Stepper Motors to replace the connected cables with GX16…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Use:
I used this Cover from @tijao at my MPCNC Nema17 Stepper Motors to replace the connected cables with GX16 connectors.
Printing:
I printed this Cover at my Prusa I3MK3S+ with RoyalBlue PLA from Prusa.
I printed 2h16m.
Build:
to connect the Cover with the Nema17 Steppers i used M3 screws. Just screw th GX16 C connector to the Cover and solder the connected cables to the connector.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0,15
Infill:
15
Filament: Prusa PLA RoyalBlue
Notes:
Printer Hardware:
Nozzle: 0.4mmI used my textured Sheet for this print.
PLA print settings:
Bed temperature: 60°C
Nozzle temperature: 210°C - first layer: 215°C
Custom Section
Changelog
09/2022
I uploaded this print in Version 2.
I redesinged this model because my screws were to short to fit in the Nema17.
I lowered the screw-holes.
The screw-holes are now little below the surface and then my screws worked.
You could read about this project on my Blog.
Category: Robotics