1 / 7
Whoop Canopies [Runcam Nano 3, Foxeer Razer Pico, LDARC 199c V2.1] — zdjęcie 1
1 / 7

Whoop Canopies [Runcam Nano 3, Foxeer Razer Pico, LDARC 199c V2.1]

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These are some files that may be of use to people who are designing adaptors or canopies for the cameras mentioned.

Ocena
0 / 5
Polubienia
8
Pobrania
140
Wydruki
0
Wyświetlenia
1092
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

The Runcam Nano 3 bracket is the same as the one used with the Mobula Canopy which attaches to the back of the Nano's backside and is attached to the canopy via 2 screws. Normally, you would print this in a rigid filament such as PLA.

The Foxeer Razer Pico adaptor is also meant to be used with the Mobula Canopy. It clips onto the camera's lens as I did not want it to be a permanent solution. This would also be printed in PLA or hard TPU.

The 199c camera canopy is a lightweight simple canopy that has a fixed camera angle of 23 degrees. I found that canopies similar to this tend to be 30 degrees or more which was too high for me. This should be printed in TPU and I can get it around 0.8g.

 

All the STLs have their corresponding .f3d files here so feel free to remix this to fit your needs or tolerances of your printer. 

Tagi