Whoop Canopies [Runcam Nano 3, Foxeer Razer Pico, LDARC 199c V2.1]
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are some files that may be of use to people who are designing adaptors or canopies for the cameras mentioned.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 140
- Makes
- 0
- Views
- 1,091
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
The Runcam Nano 3 bracket is the same as the one used with the Mobula Canopy which attaches to the back of the Nano's backside and is attached to the canopy via 2 screws. Normally, you would print this in a rigid filament such as PLA.
The Foxeer Razer Pico adaptor is also meant to be used with the Mobula Canopy. It clips onto the camera's lens as I did not want it to be a permanent solution. This would also be printed in PLA or hard TPU.
The 199c camera canopy is a lightweight simple canopy that has a fixed camera angle of 23 degrees. I found that canopies similar to this tend to be 30 degrees or more which was too high for me. This should be printed in TPU and I can get it around 0.8g.
All the STLs have their corresponding .f3d files here so feel free to remix this to fit your needs or tolerances of your printer.