Filament Spool Holder w/ 6004 ball bearings, SKÅDIS compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ever got annoyed by junkie spool holders? Fear no more, the Holder to End All Holders is here! Silent w/ 6004 bearings.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 379
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Extremly overengineered filament spool holder based on 6004 bearings.
Designed with Ikea SKÅDIS pegboard compatibility in mind using M2.5 T-Nuts, but can also be screwed/bolted directly to a wall/other pegboard. Link to T-Nuts:
https://www.printables.com/model/228663-skadis-t-nuts-mounting-system-for-ikea-skadis-pegb
Compatibility:
- at least 51mm inner diameter
- designed for 65mm wide spools, will accept up to 69mm wide
- required two 6004 ball bearings (i used Timken 6004-2RS bearings, 42mm outer⌀, 20mm inner⌀, 12mm thick)
- pressing the bearings will require some force, DO NOT HAMMER THEM IN
- cap is designed for countersank M5 bolt up to 30mm in length, it should self-tap with some force
Printing:
Material: PLA, nylon should work too. Just make sure its not to brittle to allow for press-fitting the bearings.
Layer height: shouldn't matter, just make sure 45° overhangs print well
Perimeters: at least 3
Infill: at least 20% to allow for structural integrity, cubic is fine
Supports: Required for inner part of the outer roller, otherwise turn off
Assembly:
Start with mounting the base (skadis_roller_holder) to the desired surface (M2.5 T-Nuts for SKÅDIS or any other bolt that is =< 5mm in diameter) Press-fit the bearings into outer roller (skadis_roller_roller), put on base. Screw in the cap with the countersank M5 bolt.
Project is still WIP, planning to make it more user-friendly, especially get rid of the self-tapping M5 bolt. Things have not been tested propperly so I'll try to update the project regularly.
Versions for other bearings might come soon. For remixes, I can provide Creo 10 .prt files.