Filament Spool Holder w/ 6004 ball bearings, SKÅDIS compatible
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ever got annoyed by junkie spool holders? Fear no more, the Holder to End All Holders is here! Silent w/ 6004 bearings.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 41
- Makes
- 0
- Views
- 379
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Extremly overengineered filament spool holder based on 6004 bearings.
Designed with Ikea SKÅDIS pegboard compatibility in mind using M2.5 T-Nuts, but can also be screwed/bolted directly to a wall/other pegboard. Link to T-Nuts:
https://www.printables.com/model/228663-skadis-t-nuts-mounting-system-for-ikea-skadis-pegb
Compatibility:
- at least 51mm inner diameter
- designed for 65mm wide spools, will accept up to 69mm wide
- required two 6004 ball bearings (i used Timken 6004-2RS bearings, 42mm outer⌀, 20mm inner⌀, 12mm thick)
- pressing the bearings will require some force, DO NOT HAMMER THEM IN
- cap is designed for countersank M5 bolt up to 30mm in length, it should self-tap with some force
Printing:
Material: PLA, nylon should work too. Just make sure its not to brittle to allow for press-fitting the bearings.
Layer height: shouldn't matter, just make sure 45° overhangs print well
Perimeters: at least 3
Infill: at least 20% to allow for structural integrity, cubic is fine
Supports: Required for inner part of the outer roller, otherwise turn off
Assembly:
Start with mounting the base (skadis_roller_holder) to the desired surface (M2.5 T-Nuts for SKÅDIS or any other bolt that is =< 5mm in diameter) Press-fit the bearings into outer roller (skadis_roller_roller), put on base. Screw in the cap with the countersank M5 bolt.
Project is still WIP, planning to make it more user-friendly, especially get rid of the self-tapping M5 bolt. Things have not been tested propperly so I'll try to update the project regularly.
Versions for other bearings might come soon. For remixes, I can provide Creo 10 .prt files.