SV07+ Glass Bed Input Shaper Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you have a glass bed then you dont have Input shaper mounting points anymore, this fixes it.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 297
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is the solution to your glass bed input shaper mounting problems. The print in places ones either don't fit, or come loose. this one is extremely tight and provides great strength for your test. The results are great.
Material to complete:
- (1) M3 x 16 mm screw
- (3) M3 hex nut
- (1) M3 x 20 mm screw
- (2) M3 x 4 heat inserts(I used 5mm length)
optionally:
- (1) M4 hex nut
- (1) M4 x 20 mm screw
Additionally you will need 1-2 M3 x 16 screws for attaching the input shaper.
Pretty simple from here, print it out with 50% infill for everything but the jaw. The jaw needs to be solid! Optionally make it all solid. I used layers at 0.2 and I supported the screw holes with tree supports. I printed at 100mm/s with a quality of 0.02.
Doesn't matter what material, as we will be using it on a cold bed.
once printed, if the tolerances are too tight for the nuts, place it where it should fit and thread in the screw and tighten until the nut is pulled into its spot.
If you want the larger dimensioned screw for the knob, you wont be able to place a nut at the end of the bracket, but it should be fine.