Led strip holder for Lack enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the great design from Punkgeek. I reduced its length to 21,5cm to fit in a Prusa Mini plate.
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 170
- Wydruki
- 4
- Wyświetlenia
- 1604
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of the great design from Punkgeek.
The length is reduced to 21,5cm to fit on a Prusa Mini plate. I left the angle to 30° but I changed the width to 10mm for my WS281x led strip.
You can print 2 of them per side of the enclosure for a great look and huge illumination. I went for 6 in my setup.
I printed it with PETG because of a temperature matter. I thought the led would heat a lot, but I must say they doesn't, so PLA should be ok as well.
My strip is a SK6812 RGBW, controlled by octoprint with the “WS281x LED Status” plugin.