Eclipson model C anchor nut for square nut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The standard anchor nut for the model C isn't great. This one takes a square nut which is much easier to fixate.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 439
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
The standard anchor nut for the model C isn't great. This one takes a square nut which is much easier to fixate.
The original anchor for the model C has a nut-hole that is too large for the required M3 nut, and will spin around if you don't glue it in. After fully assembling the body I came to this conclusion which was a pain to fix without throwing the whole body into the trash.
Be kind to yourself: get some square M3 nuts and print these nut anchors instead.
Press the nut into the hole all the way with a screwdriver. It should be very tight in the hole. If you have a hard time just scale the model 2% in the direction that doesn't fit for you.
Print this model with the large flat side facing down, the sidewith the cross cut-out. No supports required.
FYI This model is for this (great) model airplane: https://www.eclipson-airplanes.com/modelc