Eclipson model C anchor nut for square nut
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The standard anchor nut for the model C isn't great. This one takes a square nut which is much easier to fixate.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 38
- Makes
- 0
- Views
- 439
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
The standard anchor nut for the model C isn't great. This one takes a square nut which is much easier to fixate.
The original anchor for the model C has a nut-hole that is too large for the required M3 nut, and will spin around if you don't glue it in. After fully assembling the body I came to this conclusion which was a pain to fix without throwing the whole body into the trash.
Be kind to yourself: get some square M3 nuts and print these nut anchors instead.
Press the nut into the hole all the way with a screwdriver. It should be very tight in the hole. If you have a hard time just scale the model 2% in the direction that doesn't fit for you.
Print this model with the large flat side facing down, the sidewith the cross cut-out. No supports required.
FYI This model is for this (great) model airplane: https://www.eclipson-airplanes.com/modelc