Scarlet 2i2 Gen 3 under desk mount (Remix-Original by iamthewouf)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the amazing, yet minimalistic mount by iamthewouf on Thangs.com added a voud in the bottom for the feet.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 383
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Added a void in the bottom for the feet to “rest” so they do not have to be removed, i wanted to keep mine stock in case i ever wanted to desk mount it again. The feet could vary slightly in its locations hence i made a big void instead of precise divets.
Due to the clamping nature and naturally compresiveness of the feet, it should hold in place.
Also extended the baseplate to be a bit thicker for rigidity ( not nessesary the original is good enough! )
Original by iamthewouf on thangs.com https://thangs.com/designer/iamthewouf/3d-model/Scarlett_2i2_under_desk.STL-51817
Infill: 20-100%
No supports needed, slower print speeds for nicer corners/facade. The inner voids for the screws should have good overhangs even for hte wrost of printers, also their out of sight.
Printed out in: CF-PETG, any material should suffice. Note that if your room gets a lot of sunlight, better select a more UV resistent fillament, on a older design i used i had my print crack due to this.
Brims, are REQUIRED if you do not run an enclosure. Due to the long and thin nature of the print, it has a tendecy to curl.
*Note:
As its a remix, of someone from another site i disabled any remix cultures etc, of THIS specific model. If you want to modify it, please use the original as linked above. The person in quesition was gracious enough to profide step files etc.