Ryobi Battery Charger Mount for Multiboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for a Ryobi battery charger for the Multiboard 3D printed storage system.
- Ocena
- 5 / 5
- Polubienia
- 143
- Pobrania
- 664
- Wydruki
- 4
- Wyświetlenia
- 4761
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount for a Ryobi battery charger designed for the Multiboard 3D printed storage system. The model can be printed in most any material and default settings.
The mount is really simple, it is two custom multiboard snaps with recessed M4 nuts and two M4 x 12mm (or so) button head screws.
Snap the snaps into place six grid spacings apart with the top snap's hole offset point down. Oriented the bottom snap's hole on the topside. The hole to hole spacing is 140mm to match the battery charger's mounts.
Note, these snaps are not as secure as the threaded bolts used on my other designs. In the future I will likely replace them with something that is difficult to pull out of the Multiboard. This is only an issue when trying to remove the charge given it provides a larger lever arm.
The two snaps have an identical offset and are the same.
I also printed a multiboard pegboard hook for hanging the power cable.
This is part of a family of Ryobi Multiboard mounts designed with a similar look and feel that mount the tools parallel to the wall with the labels facing out. This along with some creative position on the Multiboard presents a clean organized well designed aesthetic.