IEC C14 Receptacle Dustproof Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D Printable Dustproof Cover for an IEC C14 Receptacle
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 105
- Wydruki
- 0
- Wyświetlenia
- 527
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Model
3D Printable Dustproof Cover for an IEC C14 Receptacle.
Print Settings
Make sure to print the IEC C14 Unfolded Rubber Dust Cover in a flexible TPU filament with 8+ perimiters, this will help to prevent tears in the thin bendy arms. You can print the IEC C14 3D Pinted Housing however you would like.
Parts needed
1 x IEC C14 Unfolded Rubber Dust Cover
1 x IEC C14 3D Pinted Housing
2 x M4 Countersunk screws
2 x M4 Nuts
Installation
(1) Print out the IEC C14 Receptacle Dustproof Cover (Technical Drawing) and cut out the 1:1 Cutout diagram. Use this as a template to drill 1x 33mm hole and 2x 4mm holes 22mm from the centre of the 33mm hole.
(2) Place the IEC C14 Unfolded Rubber Dust Cover over the hole and on top place the IEC C14 3D Printed Housing. Then insert your IEC C14/13 receptacle into the hole making sure to hold all parts in place with either one hand or tape.
(3) Screw in the receptacle into your panel using 2x M4 nuts behind, make sure that you have assembled the parts as shown in the IEC C14 Receptacle Dustproof Cover (Technical Drawing).
Disclaimer
I have not tested this receptacle outdoors or in the weather, I am only using it as a mudcover for the charger input on an Enduro Ebike. Please take extreme care when mixing water and mains electricity, improper care or installation could lead to serious injury or death.