1 / 1
STC-1000 case for Prusa Enclosure
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for an STC-1000 temperature controller to replace the thermometer included with the Prusa Original Enclosure
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 423
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The STC-1000 is a temperature controller that can be used to run a heater to maintain a constant temperature in your enclosure. This case houses the STC-1000 in the corner where the small thermometer normally resides. It provides two holes for PG9 cable glands for the power input, and heater power output, and a third smaller hole for the temperature probe wire.
Printing
- Material: PETG (or not, I'm not the boss of you, if you're heating your enclosure maybe you want to use ASA or PC)
- Settings: Nothing Special
- Print in the orientation provided, and just go for it. Shouldn't need supports, unless you're scared of the bridge over the top of the controller.