1 / 1
STC-1000 case for Prusa Enclosure
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case for an STC-1000 temperature controller to replace the thermometer included with the Prusa Original Enclosure
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 37
- Makes
- 0
- Views
- 423
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
The STC-1000 is a temperature controller that can be used to run a heater to maintain a constant temperature in your enclosure. This case houses the STC-1000 in the corner where the small thermometer normally resides. It provides two holes for PG9 cable glands for the power input, and heater power output, and a third smaller hole for the temperature probe wire.
Printing
- Material: PETG (or not, I'm not the boss of you, if you're heating your enclosure maybe you want to use ASA or PC)
- Settings: Nothing Special
- Print in the orientation provided, and just go for it. Shouldn't need supports, unless you're scared of the bridge over the top of the controller.