ESP32 38 pin breakout board case (snap-fit lid)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case with snap-fit lid to fit ESP32 breakout board
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 1095
- Wydruki
- 1
- Wyświetlenia
- 4398
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Designed this case with a snap-fit lid to fit a 38 pin ESP32 breakout board, you'll find these all over aliexpress/ebay/amazon, etc.
The case has symmetrical cutouts to access the terminals on either side, so you can mount the board in any orientation. You should also be able to access the usb-c/micro-usb port whilst the lid is off, without needing to remove the board from the case. The board can be screwed into the case leveraging some heat set inserts and 4 bolts.
I am personally using this mounted with some double-sided 3M VHB tape.
Required hardware:
- Heat set inserts: M3 x L6 x D4. Maximum length can be 7mm, this is just what I used.
- 4 x bolts: M3 x 8mm
- Optionally, some double-sided tape to mount it.
Printed this model? Show the community what it looks like by posting your make.
Like this model?