1 / 2
ESP32 38 pin breakout board case (snap-fit lid) — image 1
1 / 2

ESP32 38 pin breakout board case (snap-fit lid)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Case with snap-fit lid to fit ESP32 breakout board

Rating
5 / 5
Likes
40
Downloads
1,085
Makes
1
Views
4,382
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

Designed this case with a snap-fit lid to fit a 38 pin ESP32 breakout board, you'll find these all over aliexpress/ebay/amazon, etc. 

The case has symmetrical cutouts to access the terminals on either side, so you can mount the board in any orientation. You should also be able to access the usb-c/micro-usb port whilst the lid is off, without needing to remove the board from the case. The board can be screwed into the case leveraging some heat set inserts and 4 bolts.

I am personally using this mounted with some double-sided 3M VHB tape.

Required hardware:

  • Heat set inserts: M3 x L6 x D4. Maximum length can be 7mm, this is just what I used.
  • 4 x bolts: M3 x 8mm
  • Optionally, some double-sided tape to mount it.

 

Printed this model? Show the community what it looks like by posting your make.

Like this model?

Tags