Basement window vent for laser engraver 4 inch 100mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Need to vent in basement, wanted a damper to open and close
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 129
- Wydruki
- 0
- Wyświetlenia
- 1361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed to vent a new laser engraver and wanted to set something up that could slide into my basement window and have a vent for casual use to open or close if the weather was being nasty. I added ¼" weather stripping around all edges.
The remaining parts for the valve etc I didn't modify although if I was printing another I might beef them up a bit as the shaft feels a little wimpy.
I used the cut tool in Prusaslicer to make it fit with dowels with glue and a strip of duct tape to stop any leaks.
I also made a coupler from the vent body, I wanted that ridge on it so the zip ties would be on there and they couldn't come apart.