Solder Fume Extractor (Solder Smoke Box)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small extractor for those nasty smolder fumes, based on a 120mm PC fan.
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 171
- Wydruki
- 1
- Wyświetlenia
- 1263
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A simple solder fume extractor that uses a 120mm PC fan and two 130x130mm activated carbon filters.
Both the fan and the filters can be easily sourced from Amazon or similar. I am using a 120mm fan that is plugged in via USB. Albeit a bit weak, it is still strong enough to suck away the solder fumes.
The model is a single piece print. Depending on how much you trust your printer with overhangs, you may want to enforce support for the two large overhangs. The smaller overhangs in the honeycomb pattern should work fine without supports.
My filters where advertised as 130x130mm, but side lengths are more like 130+/-5mm, thus the model was designed with some variance in mind.
Assembly
- Clean your print if you want, the honeycomb will not be visible, so any stringing there can be ignored
- Push in the 120mm fan and make sure the cable is on/near the top side.
- The fan should sit tight with friction alone, but you can use the fan's screws to secure it in the printed part. Tweezers can help getting the screws into position.
- Slide in one filter at the front and one at the back.