Spool Winder Adapter for Power Drill
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to mount Filament Spools with a bolt onto a Power Drill
- Ocena
- 5 / 5
- Polubienia
- 86
- Pobrania
- 621
- Wydruki
- 10
- Wyświetlenia
- 3525
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When dealing with lots of spools and especially with refill filaments, sooner or later you will find yourself with a tangled spool which can only be saved by respooling the filament. So I was looking for a quick and easy solution to rewind the spool with a power drill and found this adaptive design which should fit any spool. There are some other models with printed axis and hex/bit adapters, but I think they're not strong enough and wear out pretty quickly, so I went with steel…
All you need is a M8 or M10 threaded bolt and some hex nuts.
Printed in PLA or PETG with 0,2mm. No supports required. The shown model is the M10 version printed in Prusament PETG Prusa Orange.
I created the hex insert with SVG layers, so if you want to slice it yourself make shure to use Prusaslicer v2.7 or higher:
