Extension Cord Reel - 50ft (15m) - Ambidextrous

This pushes the outer limits of the X1C's 256mm bed. It's 250mm in diameter. If you're a perfectionist, pause the print and remove the purge lines before letting the first layer go down. It's easy enough to trim it off if you don't. I used PLA+ but my next one will probably be ASA. 

Here's everything else you need to know.

Hardware

• 10x M3x5 screws (for attaching sides to reel center)
• 6x M3x6 screws (to attach retaining lips to handle)
• 2x M3x12 screws (to attach handle sides)
• 2x 608 Bearings -  https://www.amazon.com/gp/product/B09PKD8QZZ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Other info

• Make sure to use supports on the handle pieces (gray) or you're going to have a bad time.
• You might want to print the pin that connects the knob to the side with more walls than the other pieces. I used 5 walls and bumped up my infill (gyroid) to 25% just to make sure it was strong enough. 
• Assemble all the parts in orange first; then, the handle will be attached from each side.
• I increased the tolerances on the threads for the center pieces. It was a super tight fit and I had to spend about 20 minutes sanding to get them to go together right.