Kraft RX-044 RX-045 Einhandzwingen Verbinder (customizable Quick Grip Bar Clamp Coupler)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recently I found this nice coupler for Parkside or Powerfix quick grip bar clamps:…
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 133
- Wydruki
- 1
- Wyświetlenia
- 735
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Recently I found this nice coupler for Parkside or Powerfix quick grip bar clamps:
https://www.printables.com/model/698050-parkside-klemmenverbinder
It prints & fits really nice on said clamps, but I don't have a lot of them.
Most of my cheap quick grip clamps are "Kraft" or "Walter" branded clamps sold by NORMA, a competitor of LIDL supermarkets here in Germany.
The "Kraft" clamps are actually built a little sturdier than the Parkside ones, especially the lever mechanism is quite a bit more solid.
So I took some measurements and went to recreate a similar coupler for Kraft RX-044 (150mm) and RX-045 (300mm) clamps in OpenSCAD.
I put some comments in the .scad file, so it should be possible to adapt this coupler to other makes / dimensions of similar quick clamps.
I also added texts on both sides, so different couplers can be marked differently and don't get mixed up.
Print Settings
Printer Brand:
Sovol 3D
Printer:
Sovol SV06
Rafts:
No
Supports:
Yes
Resolution:
0.2 mm
Filament:
Jayo PLA+
Notes:
I got best results by printing the coupler in the provided orientation in 0.2mm resolution with tree type supports enabled (the .stl file only generates minimal support in Cura 5.3.1)
Category: Hand Tools