DJI O3 Air Mount/Cradle for Titan Dynamics Micro Talon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for a DJI O3 Air unit for a Titan Dynamics Micro Talon 3d printed RC (remote controlled) airplane.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 122
- Wydruki
- 0
- Wyświetlenia
- 945
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This cradle is supposed to hold the DJI O3 Air Unit. Two of the mounting screws of the air unit need to be replaced with slightly longer ones (M1.6). The cradle itself attaches to a modified “fuse1” part of the Micro Talon. I'm using four M3x4x4 inserts (not M3x4x5), but x5 probably “fits” as well.
The provided modified “fuse0” part is for the camera of the DJI O3 system. Personally, I prefer to print it with the nose (aka the lens side) down with a generous brim.
I recommend to use a high temperature filament like Nylon/PA since the air unit is known for getting hot.
DISCLAIMER: I have not flown this setup yet, so I can't comment on how well the cooling actually works. Use at your own risk!