Eibos Easdry - Voron Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Parts needed:
M3 screws
M3 heat inserts
M3 hammer-nut or T-nut
Recommended print settings:
easdry _holder - 0,2mm
- 25% infill
- 4 perimeters
- 4 top and bottom layers
easdry_mount - 0,2mm
- 40% infill
- 5 perimeters
- 5 top and bottom layers
Recommended filament:
ABS or at least PETG
Assembly:
Place the heat inserts into the mounts first. Then attach the mounts to the top extrusions. I used two T-nuts on the top and hammer-nuts on the sides. Do not fully tighten them yet. Next, attach the holder to the mounts using screws and position the entire assembly according to your preference. Finally, tighten all the screws.
You can also use the PTFE coupler to connect the PTFE tube from Easdry to the PTFE tube of the Voron.