Team Associated B7 Oring Battery Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The new B7 battery mount system is pretty good actually but with my low profile batteries there was quite a bit of…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 647
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
The new B7 battery mount system is pretty good actually but with my low profile batteries there was quite a bit of vertical play, obviously I could put some foam etc but decided I'd try to create an oring mount.
You'll need a 61mm (inside diameter) 2mm thick oring. Very cheap to buy from eBay. You can probably get away with a little smaller ID. I originally tried a 44mm, it was very tight but did technically stretch. I ordered the 61mm and it was good for me. I reckon 55mm would also be more than fine, possibly a little smaller.
Just print two and screw in. It's the standard offset, I havent bothered doing the 1/2 offset yet but might do at some stage.
Print Settings
Printer Brand:
Bambulabs
Printer:
Bambu P1S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: Generic PETG Black
Notes:
I'd recommend PETG or ABS, I dont think PLA would take the heat inside the shell.
Category: R/C Vehicles