Team Associated B7 Oring Battery Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The new B7 battery mount system is pretty good actually but with my low profile batteries there was quite a bit of…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 87
- Makes
- 0
- Views
- 647
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
The new B7 battery mount system is pretty good actually but with my low profile batteries there was quite a bit of vertical play, obviously I could put some foam etc but decided I'd try to create an oring mount.
You'll need a 61mm (inside diameter) 2mm thick oring. Very cheap to buy from eBay. You can probably get away with a little smaller ID. I originally tried a 44mm, it was very tight but did technically stretch. I ordered the 61mm and it was good for me. I reckon 55mm would also be more than fine, possibly a little smaller.
Just print two and screw in. It's the standard offset, I havent bothered doing the 1/2 offset yet but might do at some stage.
Print Settings
Printer Brand:
Bambulabs
Printer:
Bambu P1S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: Generic PETG Black
Notes:
I'd recommend PETG or ABS, I dont think PLA would take the heat inside the shell.
Category: R/C Vehicles