1 / 26
Gear Bucket Organizer for Hobie 8" Hatch — zdjęcie 1
1 / 26

Gear Bucket Organizer for Hobie 8" Hatch

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a gear bucket system for the 8" round hatches found on Hobie kayaks and boats. There are various tray…

Ocena
0 / 5
Polubienia
33
Pobrania
263
Wydruki
0
Wyświetlenia
1211
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a gear bucket system for the 8" round hatches found on Hobie kayaks and boats.

  • There are various tray configurations and sizes to organize your tackle / gear / accessories.
  • The bucket will print on a 25cm x 20cm build plate (Prusa i3).

STEP 1

CHOOSE A BUCKET TYPE

OPTION 1: Solid wall

Bucket has solid walls like the stock bucket.

OR OPTION 2: Perforated wall

Bucket wall is full of holes to reduce material and weight.


STEP 2

CHOOSE A BUCKET PRINT METHOD

OPTION 1: Print as 2 separate pieces

Print the 2 parts in opposite orientation to eliminate the need for print supports.

  • Bucket_solid_top.stl + Bucket_solid_bottom.stl

or

  • Bucket_lite_top.stl + Bucket_lite_bottom.stl

OPTION 2: Print as one single piece

Print the bucket in one single piece. Requires supports.

  • Bucket_solid_one-piece.stl

or

  • Bucket_lite_one-piece.stl

STEP 3

ASSEMBLE BUCKET

  • If you printed the bucket in 2 separate pieces, assemble them now.
  • The bottom will fit snugly into the top part.
  • Use glue to bond the parts together. The type of glue will depend on the material you are using.
  • If you printed the bucket as 1 single piece, simply remove the supports and you're done.

STEP 4

PRINT TRAYS

Choose and print the trays you want to use. There are several different configurations at several sizes. You can stack 3short trays, 2half trays or 1tall tray.


Notes:

  • I use PETG. It has decentheat tolerance and is prettystrong. Nylon/ABS or carbon fiber reinforced filament would be better options if you can print them.

*Print the bucket at 100% infill. You want it to be as strong as possible. I suspect the lip of the bucket is going to be the weakest point / first point of failure, so use a bit more material here to get more strength.

  • There is ample surface area to bond the bucket bottom to the top. It's a snug fit. If you use the correct glue, thatbond will be strong.
  • If you want to print ashorter bucket, cut the top off theBucket top part in your slicer (or cancel the print at the desired height). You can similarlyshorten trays in your slicer if you need to.

Category: Sport & Outdoors

Tagi