1 / 3
Nevermore V6 Micro Aux Fan Duct Adapter [Proof of Concept] for Voron V0 — zdjęcie 1
1 / 3

Nevermore V6 Micro Aux Fan Duct Adapter [Proof of Concept] for Voron V0

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Proof of Concept for an aux fan duct adapter for Nevermore V6 Micro activated carbon filters.

Ocena
0 / 5
Polubienia
18
Pobrania
70
Wydruki
0
Wyświetlenia
1109
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

A fanduct that can be used instead of a carbon filter cartridge on a Nevermore V6 Micro. Attaches using magnets, keeps clearance for Rainbow on a Matchstick. As the model is currently prone to warping on the floor, there's clearance for gluing TPU filament (1.75mm ⌀) in the hopes that that will create a good seal.

Fits on a V0 print bed and prints up-right. CFD as per TeachingTech's tutorial assuming 10CFM for two GDSTime 5015 fans.

If you're printing this, I'd appreciate a comment that addresses the following:

  • Did you have warping issues? If not, what's your magic trick + filament?
  • What fan models do you have?
  • Which toolhead do you use?
  • Does the airflow hit the bed properly? (Bonus if you have the V0 Aux Fan for comparison)

BOM

  • 4x 6mm⌀ x 3mm magnets

Print Settings

  • Material: Prefer ABS/ASA, use PETG only if necessary
  • To avoid warping/lift-off from the bed:
    • 2-3 Walls
    • 10-15% Gyroid infill at most
    • Uncheck “Detect narrow internal solid infill”
    • Infill & Bridge Directions so that the lines aren't parallel with the long side, but perpendicular

Versions

  • V21 - Groove for a printed TPU seal, same CFD as V18
  • V18 - No groove for TPU as that's prone to cracking, but an excellent CFD
  • V14 - Still warps, airflow seems to be uncompromised. groove for TPU filament works well.
  • V13 - Untested, longer wide bottom segment to hopefully avoid warping. Might compromise airflow
  • V12 - Warps but works

Shout-Outs

To Pepper and GreenPlasticWateringCan for printing all the broken prototypes and to SquidMan for telling me to scrub my build plate and to ditch the glue!

Tagi