Prusa XL X axis dial indicator mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
X Axis dial indicator mount for checking and adjusting bed level
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This mount clips onto the X-axis rail of the Prusa XL and holds a dial indicator with a 3/8" (.375") stem.
I used this to check and adjust the bed level after receiving my XL. I found mine was out a total of .052" (1.32mm) difference from front to rear of the heat bed frame. with this I was able to adjust within .001".
A quick way to tell that you need adjustment is by placing a piece of tape near the bottom of one of the Z axis lead screws and then watch a test print. If you have a test print that moves all the way from the front to the rear of the heat bed, and you see more than ½ rotation of the lead screw, you might want to adjust level and save some wear on the lead screw nuts.
Printed from PETG
- .2mm layer
- 3 perimeters
- 20% Gyroid infill
- printed in about 35 minutes on my MK3s+