1 / 4
Big Blue to Dive Rite QRM adapter, zipties + screw attachement — zdjęcie 1
1 / 4

Big Blue to Dive Rite QRM adapter, zipties + screw attachement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows attachment of a Big Blue light head to a Dive Rite QRM mount using two zipties and an M3-15 screw.

Ocena
0 / 5
Polubienia
3
Pobrania
42
Wydruki
0
Wyświetlenia
395
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I started with a Dive Rite QRM universal adapter, but found that it wasn't ideal for my Big Blue TL3800P light head since the light tended to rotate, and the rear ziptie tended to slip off the light head. I also didn't like the BigBlue mounting solution in general, since it places my expensive light at the mercy of a single screw. 

If I had both the screw and the zipties, my light would not rotate and I would have the redundancy in how the light is secured.

I added two holes for zipties to the model designed by aajq58 on Thingiverse. Additionally, in the model specific to the TL3800 head, I've added some offset surfaces that make contact with the light head for further support where the zipties secure the light to the mount body.

I printed it at 100% infill in PETG with supports on the lower overhangs and in the lower M3 socket counterbore, but left the ziptie holes open. It would probably print fine with no supports at all, but your results may vary. The infill is probably excessive.

Attaches to the light via one M3-15 socket cap screw and two zipties.

Tagi