Zipper Pull - Super Star (Super Mario)

Items you need:

• 2 x “4mm x 30cm” paracord.
• *4 x “3mm (diameter) x 2mm (thick)” magnets (neodymium magnets are recommended for better holding power).
• Super glue (for components and magnets).

*If you do not have magnets, I have included a 3D printed Connector.

Suggested print settings for the Main Body:

• Layer height 0.2mm.
• Infill 30%.
• Position the print in a way that the joining face is facing downwards.
• No supports needed.

Suggested print settings for the Eyes:

• Layer height 0.2mm.
• Infill 15%.
• Brim (needed if bed adhesion is insufficient):
  • Width - 2mm.
  • Brim Separation Gap - 0.2mm.
• Position the print in a way that the chamfered face is facing upwards.
• No supports needed.

Assembly

Note: This 3D print includes small components. Tweezers may be necessary for assembly. 

For the eyes, affix the chamfered side to the main body. Ensure the smoother side (the side on the print bed) is facing outwards.

For more interesting zipper pull charms, be sure to track this tag (Zipperrific).

We've even conjured up a little home for our zipper pulls – because they deserve a stylish rest when they're not out and about with you! And to top it off, each zipper pull features a sneaky slit perfect for showcasing photos, name cards, and more. They're not just zipper pulls; they're your new tiny, table-top pals! 🌟

NOTE
Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.