Satsana 4010 Fan Duct for Geeetech Mizar S, Mizar Max and Mizar Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A dual-duct upgrade hotend enclosure for the Geeetech Mizar S. Should also be compatible with Max and Pro.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 480
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I've spent several hours slowly chopping away at the original Satsana model for the Ender 3 to fit it for this printer. The original design doesn't even remotely fit the Mizar S, so a lot of work went into trying to move parts around and adding on the mounts that I had reverse-engineered from the original hotend cover, which I used in another design posted here.
Great efforts have been made to retain the functionality of the original design while trying to shoehorn the thing to fit around the oddball layout of the Mizar.
1: LED is in the way of the duct. You will need to either relocate the LED or snip it off or bend it up and out of the way, depending on your preference. For me, I desoldered the LED and mounted it on the other side of the PCB so that I could bend it slightly to give the duct clearance.
2: While the front fan wire is long enough to reach, the blower fan wire is not. Please solder a longer wire / extend the existing wire, or replace the fan with one that has a longer cable. I chose to extend the wire, it was very simple.
3: Last bit of advice - use tree supports only touching build plate, otherwise it will build supports all inside the duct.
Creator of the original Satsana on which this is based - https://www.thingiverse.com/eric-anastas
Edit - V1.5 of the top and v1.6 of the bottom have been added. They are now separate pieces to be printed. Due to the odd mechanism for mounting the hotend shroud on this printer, I haven't yet figured out a way to enable printing the whole thing on its back support-less like the original Satsana was for the Ender 3. Splitting them allows you to use different support settings for the two halves. For instance, v1.6 (with Slicing Tolerance set to Exclusive) can be printed support-less while standing up. There are grooves modelled into the bases of both halves, and guide pins can be printed to help you line the pieces up for adhesion. I recommend gorilla glue gel.
