Skadis Top Shelf 20cm or 18cm Width and 18cm Depth

Thanks to Just Joshi for this original part. 

The Shelf has a depth of 18cm. There are 2 variants in the width, one with 18cm and one with 20cm. Therefore it fits on all 3 Skadis models. 

For the 76cm Skadis board you take 2x 18cm + 2x 20cm. 

For the 56cm Skadis board you take 2x 18cm + 1x 20cm.

For the 36cm Skadis board you take 2x 18cm.

And if you have more than one Skadis board and use them in edges i designed 2 variants for inner and outer use. But the outer use needs a big 3d printer, because 2 sides are 36,5cm long. I used an Anycubic Kobra 2 Max.

For ex.: 2 Skadis boards in an edge. 1x 76cm and 1x 56cm. If you want to completely fill out the Top you would need for the 76cm board 1x 18cm + 2x 20cm + 1x inner edge. For the 56cm board you would use the inner edge from the 76cm board + 1x 20cm + 1x 18cm.

Print instructions:

Filament: PLA

Supports: Not needed

Brim: I didn't use, but for better adhesion you could use)

Infill: 10%

Printbed: 60°C first layer, other 55°C

Cooling: 75-100%

Heat: 210°C first layer, other 205°C

Speed: 80-100mm/s

Maybe you add print bed glue or other adhesion on the printbed for the bigger parts. Otherwise the edges could go up…

I added print files for PLA (i printed it with PrimaCreator PrimaValue PLA Dark Grey) and as 3d printer i used the Anycubic Kobra 2 Max. But on print i switch it to “stable”. The layer height of the print ist 0.15mm

Update: Another shelf 18(19)cmx18cm and the inner edge corner 18(19)cmx18(19)cm added with recesses for wall mounts.

And If you are looking for a doublesided Design for you skadis Board as Desktop mount, try this:

https://www.printables.com/de/model/776480-ikea-skadis-top-shelf-doublesided-365cm-x-18cm-20c