Open differential for 3Dsets Jeep Rancher
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is open differential for Jeep Rancher from 3dsets.
- Ocena
- 0 / 5
- Polubienia
- 103
- Pobrania
- 384
- Wydruki
- 2
- Wyświetlenia
- 3480
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
This is open differential for Jeep Rancher from 3dsets. I test it on version Wagon, but should be possible to mount it also on other versions.
I created it this open diferencial, because I'm using my Rancher in house on vinyl floor and the adhesion is so good - and it overloads cardan joints.
The idea was to use maximum of original parts. For two pieces of differential you need only:
6x bearings 10X15X4 6700 2RS (same like is used everywhere in Rancher)
10x screw M3x12
and 3d printed parts
Print settings for case/box 0.2mm-20%, all other parts 0,15mm-100% infill
I printed on Prusa Mini
Assembly manual should be clear from photos.
Don't forget put in grease.
NOTE: Maybe it will be necessary to shorter Drive Shaft - Differential side, because new differential is little bit longer. On my Wagon version I did only for front axle.