1 / 2
T_B_A's BLTouch Holder for E3D Hemera, but turned around — zdjęcie 1
1 / 2

T_B_A's BLTouch Holder for E3D Hemera, but turned around

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

T_B_A's BLTouch Holder for a 40x40x20 Hotend-fan is kind of nice, it needs to be fit tight on the fan to hold.…

Ocena
0 / 5
Polubienia
2
Pobrania
18
Wydruki
0
Wyświetlenia
144
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

T_B_A's BLTouch Holder for a 40x40x20 Hotend-fan is kind of nice, it needs to be fit tight on the fan to hold.


However, if you turn it 180° around, the little edge of the holder are perfect to hold the mount between the fan and the Hemera :-)

So, my work here is just turning around the Fan-Bracket 180° and then re-adjust the bltouch-holder to have the right height.

 

With a standard V6 heatblock and an original BLTouch the Nozzle to Probe Z-OFFSET is around -0.3 to -0.8 mm. Your installation may vary a bit.

Start with:

define NOZZLE_TO_PROBE_OFFSET { -24.5, -44, -0.3}

and fine tune from there. 

It fits nicely together with the Permanoob's 5015 Fan-Shroud: https://www.thingiverse.com/thing:4031637

 

Tagi