Case for 4-1 Retro Game Console Kit HU-001 SH00108
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an easy-to-print case for the DIY retro-gameconsole, like the one here: https://www.roboter-…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 183
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an easy-to-print case for the DIY retro-gameconsole, like the one here: https://www.roboter-bausatz.de/p/bausatz-diy-retrokonsole-tetris-snake-racing-space-shooter
As mine came without a case kit, I designed one in Tinkercad.
See thePost-Printing-Section for assembly instructions.
Print Settings
Printer Brand:
Creality
Printer:
CR-6 SE
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament: your choice PLA your choice Post-Printing =============
Assembly is self-explaining....
Just print the two halves, install the PCB in the upper half (three small screws needed - btw: who designes a PCB layout with only 3 mounting holes???).
(the screw holes in the upper half are designed kind of slots, so you can adjust the PCB position to align buttons with corresponding holes!)
Then use a double-sided adhesive tape to fix the battery holder inside the bottom part.
Put both parts together - make sure the TOP marking on the lower parts points to the top, because there is a support column for the PCB in the bottom case to compensate for the missing 4th screw.
There you are!
PS: I attached a red plastic sheet between case and LED displays to enhance contrast of the display. I salvaged that from a plastic file cover and fixed it with small melting points made with my soldering iron...
Category: Electronics